Siemens SCALANCE W786-1 RJ-45 User Manual

Configuring with Web Based Management
6.9 "Security" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
384 Configuration Manual, 08/2018, C79000-G8976-C267-13
●
Ingress Interfaces
Shows a list of all ingress interfaces to which this rule applies.
●
Egress Interfaces
Shows a list of all egress interfaces to which this rule applies.
Note
Entering the MAC addresses
You can confi
gure access rules for MAC addresses.
Only if you enter the address "00
-00-00-00-00-00" for the source and/or destination MAC
address, the rule created in this way applies to all source or destination MAC addresses.
Note
Loop detection
Activating loop d
etection can prevent rules for Multicast MAC addresses from being applied.
Note
No ACL rules for locally supported protocols
ACL rules are not applied to packets from locally supported protocols. This restriction applies
to the following protocols:
•
DCP
•
LLDP
•
RSTP
•
MRP
Make the specifications for receiving and sending packets for these protocols directly on the
configuration page of the respective protocol.
Configuration procedure
1. Click the "Create" button. A new row with a unique number (rule number) is created in the
table.
2. Enter the MAC address of the source in "Source MAC Address".
3. Enter the MAC address of the destination in "Dest. MAC Address".
4. In the "Action" drop-down list select whether the frame is forwarded or rejected when it
corresponds to the ACL rule.
5. Click the "Set Values" button.

Siemens SCALANCE W786-1 RJ-45 Specifications

General

Brand	Siemens
Model	SCALANCE W786-1 RJ-45
Category	Wireless Access Point
Language	English