Configuring with Web Based Management
6.9 "Security" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
401
When should Inter AP blocking be used?
The clients connected to an access point can normally communicate with all SCALANCE
W700 devices of the layer 2 network.
With inter AP blocking, the communication of the clients connected to the access point can
be restricted. Only the SCALANCE W700 devices whose IP addresses are configured in
"Allowed Addresses" on the access point are accessible to the clients. Communication with
other nodes in the network is therefore prevented.
The page contains the following box:
●
Enter the update interval for the ARP table.
The table has the following columns:
●
Specifies the WLAN interface to which the settings relate.
●
Specifies the VAP interface to which the settings relate.
●
Specifies the SSID to which the settings relate.
To Next Page
Loading...
Need help?
General
