Upkeep and maintenance
7.3 Embedding firmware in ConfigPack.
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
427
1. Connect to the WBM of the device on which you want to install the ConfigPack as
administrator.
2. Go to the menu "System > Load&Save".
3. In the row "ConfigPack", click the "Load" button
4. Select the ConfigPack you want to install.
5. Restart the device with "System > Restart".
If there is a different firmware version on the device to be installed compared with that in
the ConfigPack, an upgrade/downgrade of the firmware is performed. You can recognize
this by the red F-LED flashing (flashing interval; 2 sec on/0.2 sec off). Afterwards the
device is restarted and the device configuration incl. users and certificates stored in the
ConfigPack is transferred to the device.
6. Wait until the device has fully started up.
(the red F-LED is off)
7. You can log on the device again or exit the WBM.
To Next Page
Loading...
Need help?
General
