Installation
Sicore II Installation and Commissioning Guide
667/HB/52600/000 Issue 2 Unrestricted
Overhead gantry
Octagon Pole
Bracket
Table 13 – Mounting Kit Photos
The camera is NOT supplied with a mounting kit as standard. The correct mounting kit must
be ordered to suit the installation position required.
A list of standard mounting kits may be found in Appendix B Section B.2
It is recommended that a lanyard, connected to the Lanyard Connection
Point (see Figure 6 – Sicore II Rear Panel) is used at all times to secure the
camera during installation
To Next Page
Loading...
