Siemens SIMATIC ET 200AL - Page 1034

Diagnostics and maintenance
4.1 Diagnostics mechanisms of PROFINET IO
PROFINET with STEP 7 V15
Function Manual, 12/2017, A5E03444486-AH
87
Element of the data
structure
Designation according to
IEC 61158-6-10
Code
Data type /
length in bytes
IM_Software_Revision
(not at
AM_HardwareOnlyInformati
on)
Software version, follows a strict structure
(SW version prefix, for example "V", digits for
functional extension, digits for BugFix, digits
for internal change).
Example: 'V' 0x01 0x2 0x3
If AM_SoftwareRevision is padded with spac-
es, you should evaluate
IM_Software_Revision.
If the asset does not support any hardware,
the coding 'V' 0x00 0x00 0x00.
Array of Byte / 4
Prefix (character
"V", "R", "P", "U",
or "T"), then 3
digits "0" to "9"
AM_DeviceIdentification Identification of the device. The structure is as
follows:
AM_DeviceIdentification.DeviceSubID
(for SIEMENS e.g. 0x0000)
AM_DeviceIdentification.DeviceID
(Device ID from manufacturer, 0x0000 to
0xFFFF)
AM_DeviceIdentification.VendorID
(Example for Siemens assets: 0x002A)
AM_DeviceIdentification.Organization: Exa-
mple for Siemens assets: 0x0000
(PROFINET)
Array of Byte / 8
AM_TypeIdentification Manufacturer-allocated type identification:
0x0000: Unspecified
0x0001: Controller (PLC)
0x0002: PC-based
0x0003: IO module, IO submodule
0x0004: Communications module / submod-
ule
0x0005: Interface module / submodule
0x0006: Active network component
0c0007: Media attached unit (bus adapter)
0x0100 to 0x7FF: Manufacturer-specific
UINT / 2
IM_Hardware_Revision
(not at
AM_FirmwareOnlyInformati
on)
Version of the hardware (0x0000 to 0xFFFF)
Example: 0x0003
If AM_HardwareRevision is padded with
spaces, you should evaluate
IM_Hardware_Revision.
UINT / 2