Siemens SIMATIC ET 200AL - Page 109

Accessories/spare parts
C.2 Cables
Distributed I/O system
System Manual, 02/2018, A5E31861578-AF
107
Cables of power supply standard and PUR cable
The cables for the power supply are available in the following versions and lengths:
● Power cable (4-wire), pre-assembled on both sides with a 4-pole M8 pin connector/socket
connector
– available lengths: 0.19 m, 0.3 m, 1 m, 2 m, 5 m, 10 m, 15 m
● Power cable (4-wire), pre-assembled on both sides with a 4-pole M8 pin connector/socket
connector, angled
– available lengths: 0.3 m, 1 m, 2 m, 5 m, 10 m, 15 m
● Power cable (4-wire), pre-assembled on one side with 1x M8 socket connector
– available lengths: 2 m, 5 m, 10 m, 15 m
The following table shows the technical properties of the power supply cable, standard.
Table C- 12 Cables for power supply
General information
Product type designation
POWER CABLE M8
Function For connection of ET 200AL for 24 V DC power
supply
Degree of protection and protection class
IP65 Yes
IP67
Yes
Ambient conditions
Ambient temperature during mounting
minimum
-30 °C
maximum
80 °C
Storage/transport temperature
Ambient temperature during transport and storage
minimum
-40 °C
maximum
80 °C
Cables
Cable designation
4 Li9Y 0.50 mm² Y
Number of electrical wires
4
Outside diameter of the inner conductor
0.8 mm
Outside diameter of the wire insulation
1.46 mm
Outside diameter of the cable sheath
5.2 mm
Number of bending cycles 2500000; Trailing-chain suitable for 2.5 million
bending cycles with a bending radius of 52 mm, a
speed of 3 m/s² and an acceleration of 10 m/s²
Permissible bending radius
One time bending, min.
26 mm
Multiple bending, min. 52 mm
Constant bending
52 mm
Color of the cable sheath
gray