Siemens SIMATIC ET 200AL - Page 127

Product Information Mixed Configuration ET 200SP / ET 200AL
8 Product Information, 02/2016, A5E33344611-AC
Mounting
2
Introduction
For the connection of the ET 200AL I/O module via ET-Connection to the ET 200SP, you
require the BaseUnit BU-Send with the BusAdapter BA-Send 1xFC.
Requirement
● The mounting rail is mounted.
● The interface module is mounted.
Required tools
3 to 3.5 mm screwdriver (only for dismantling the BusAdapter)
Mounting BaseUnit BU-Send
To mount the BaseUnit BU-Send, follow these steps:
1. Mount the BU-Send to the right of the CPU/interface module.
2. Swivel the BU-Send back until you hear the mounting rail release click into place.
3. Move the BU-Send to the left until you hear it click into place on the CPU/interface
module.
Image 2-1 Mounting BU-Send
4. Mount the BusAdapter BA-Send 1xFC only after you have connected the bus cable for
ET-Connection (see section Connecting (Page 9)).