Connection
Product Information Mixed Configuration ET 200SP / ET 200AL
Product Information, 02/2016, A5E33344611-AC
11
6. Connect and screw the BusAdapter BA-Send 1×FC to the BaseUnit BU-Send (1 screw
with 0.2 Nm tightening torque.) To do this, use a screwdriver with a 3 to 3.5 mm blade.
7. Connect the M8 connector of the bus cable to the first ET 200AL I/O module (socket X30
ET-Connection IN). For more information about wiring the ET 200AL I/O module refer to
the system manual of the ET 200AL distributed I/O system.
Bus cable for ET-Connection
Image 3-3 Connection of the BusAdapeter BA-Send 1xFC
To Next Page
Loading...
