Connection
Product Information Mixed Configuration ET 200SP / ET 200AL
10 Product Information, 02/2016, A5E33344611-AC
To connect the BusAdapter BA-Send 1xFC, follow these steps:
1. Strip the sheath of the bus cable at the open end as follows:
Image 3-2 Connecting cable
Use the stripping tool for ET-Connection to do this. The relevant settings are shown on
the tool.
2. Pull back the locking slide of the BusAdapter BA-Send 1×FC and open the cover of the
connection element.
3. Lift the cable routing up as far as it will go.
4. Insert the unstripped single cores of the bus cable (according to the imprinted color
coding) into the cable routing as far as they will go and press the cable routing down as
far as it will go.
5. Close the cover of the connection element and push the locking slide forward.
To Next Page
Loading...
