Connecting
5.7 ET 200AL marking
Distributed I/O system
System Manual, 02/2018, A5E31861578-AF
45
Optional markings
Introduction
In addition to the factory markings, there are also optional possibilities for labeling and/or
identifying interfaces and modules on the ET 200AL distributed I/O system.
The identification labels come with each module as strips and can be machine-printed. A
strip has 10 identification labels measuring 10 x 5 mm in the color RAL9016. The
identification labels can be inserted into every module at the points provided. The
identification labels are used for channel, module and slot labeling.
The figure below shows all points where you can use the identification labels using the
example of the IO-Link Master CM 4xIO-Link 4xM12 communication module.
Figure 5-11 Optional marking
Mounting identification labels
Introduction
This section describes how to mount or remove identification labels.
To Next Page
Loading...
