Connecting
5.7 ET 200AL marking
Distributed I/O system
46 System Manual, 02/2018, A5E31861578-AF
You need a screwdriver with 3 mm blade width (only to remove identification labels).
To mount an identification label, proceed as follows:
1. Print the identification label using commercially available marking systems.
2. Press the identification label out of its holder.
3. Stick the identification labels into the cutouts provided, as shown in the figure Optional
marking (Page 45).
Mounting the identification labels is the same for all modules.
To remove an identification label, proceed as follows:
1. Carefully use a screwdriver to pull out the identification label.
Removing identification labels is the same for all modules.
To Next Page
Loading...
