Siemens SIMATIC ET 200AL - Interrupts and Alarms (2 xCount); LED Displays for Status and Errors (2 xCount)

Distributed I/O system
System Manual, 02/2018, A5E31861578-AF
47
Configuring
6
Introduction
You configure and assign parameters for the ET 200AL distributed I/O system (interface
modules and I/O modules) using STEP 7 or the configuration software of another
manufacturer.
Requirements
Table 6- 1 Configuration software and requirements
Configuration software
Requirements
Installation information
STEP 7 (TIA Portal) as of V14
for modules:
• DIQ 16x24VDC/0.5A 8xM12
• AQ 4XU/I, 4XM12
• PROFINET IO, PROFIBUS DP:
as of Support Package HSP 0194
STEP 7 online help
STEP 7 (TIA Portal) V13 SP1 or
higher for modules:
• DI 8x24VDC 4xM12
• DI 16x24VDC 8xM12
• PROFINET IO, PROFIBUS DP:
as of Support Package HSP 0155
STEP 7 (TIA Portal) V13 SP1 or
higher for modules:
• DIQ 4+DQ 4x24VDC/0.5A
4xM12
• DQ 8x24VDC/2A 8xM12
• PROFINET IO, PROFIBUS DP:
as of Support Package HSP 0156
STEP 7 (TIA Portal) V13 SP1 or
higher for modules:
• IM 157-1 PN
• IM 157-1 DP
• DI 8x24VDC 8xM8
• DIQ 4+DQ 4x24VDC/0.5A
8xM8
• AI 4xU/I/RTD 4xM12
• CM 4xIO-Link 4xM12
• none, integrated in STEP 7
STEP 7 as of V5.5 SP4 for
modules:
• IM 157-1 PN
• IM 157-1 DP
• PROFINET IO:
as of Support Package HSP 0259
• PROFIBUS DP:
as of Support Package HSP 0258