Siemens SIMATIC ET 200AL - Page 619

Setting and determining system diagnostics
4.2 Options for displaying system diagnostics
Diagnostics
34 Function Manual, 09/2016, A5E03735838-AD
Result
The device is displayed in the project tree. You open the diagnostic information in the work
area with a double-click on "Online & Diagnostics".
Information is available on the diagnostic status, cycle times, memory usage and the
diagnostics buffer.
Figure 4-5 Device in the project tree
4.2.2.3
Devices & networks
Devices & networks - Go online
You can get an overview of the current state of your automation system in the device view or
network view.
You implement the following tasks in the device view:
● Device configuration and parameter assignment
● Module configuration and parameter assignment
You implement the following tasks in the network view:
● Device configuration and parameter assignment
● Networking devices
Requirements
● STEP 7 is open.
● A project is open.
● The project view is open.