Siemens SIMATIC ET 200SP CM 1xDALI - DALI-2; IECEx; ATEX

ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
116 Manual, 06/2019, A5E46959434-AA
Appendix B Approvals
B
This chapter lists the approval for ET 200SP CM 1xDALI specifically.
Detailed references to the other approvals of CM 1xDALI are listed in the document
ET
200SP Distributed I/O system.
Note
Information of the ET 200SP CM 1xDALI
The currently valid markings and approvals are printed on the components of the ET 200SP
CM 1xDALI.
DALI-2
IECEx
The CM 1xDALI meets the requirements of the DALI-2 standards.
The CM 1xDALI meets the requirements of explosion protection according to
IECEx. IECEx classification: Ex nA IIC T4 Gc
IECEx certificate: IECEx DEK 19.0024X
The CP meets the requirements of the following standards:
● IEC 60079-0
Hazardous areas - Part 0: Equipment - General requirements
● EN 60079-15
Explosive atmospheres - Part 15: Equipment protection by type of protection 'n'
ATEX
The CP meets the requirements of the EC directive 2014/34/EU "Equipment and Protective
Devices for Use in Potentially Explosive Atmospheres".
Applied standards:
● EN 60079-0
Hazardous areas - Part 0: Equipment - General requirements
● EN 60079-15
Explosive atmospheres - Part 15: Equipment protection by type of protection 'n'
The current versions of the standards can be seen in the EC Declaration of Conformity, see
above.