Siemens SIMATIC ET 200SP CM 1xDALI - Parameters; Parameter assignment; CM 1 xDALI Module Parameters

ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
Manual, 06/2019, A5E46959434-AA
21
Parameters
4
4.1
Parameter assignment
Introduction
You configure and assign the parameters of the communication module with STEP 7 V15.1
or later versions.
In the CM 1xDALI project, you assign the parameters in the device view of STEP 7 and in
the properties tab of the communication module DALI.
4.2
CM 1xDALI Module Parameters
Module Parameters
Each CM 1xDALI has the following DALI parameters in
Module Parameters
. According to
your request, you can configure any of these parameters.
The following table shows the module parameters for the CM 1xDALI.
Table 4- 1 Module Parameters
Module Parameters
Description
Value range
Default
value
Configura-
tion in
RUN
Basic parameter
Enable integrated
DALI bus power sup-
ply
Enable or disable the DALI bus power supply.
• Enable: Use the integrated DALI bus power in the CM
1xDALI.
• Disable: Do not use the integrated DALI bus power in
the CM 1xDALI.
• Enable
• Disable
Enable Yes
Enable DALI Applica-
tion Controller
Enable or disable DALI Application Controller.
• Enable: The CM 1xDALI can send any forward frame
or receive any backward frame to the DALI bus.
• Disable: The CM 1xDALI cannot send any forward
frame or receive any backward frame to the DALI bus.
• Enable
• Disable
Enable Yes