Siemens SIMATIC ET 200SP CM 1xDALI - Dali_Ecg_Set_Ext_Param

Programming
5.7 Configuration function blocks
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
Manual, 06/2019, A5E46959434-AA
79
5.7.6
DALI_ECG_SET_EXT_PARAM
Description
DALI_ECG_SET_EXT_PARAM
is used for setting the extended parameters of DALI control
gears. The extended parameters are type-related.
● If the status of control gear is configured (for example, control gear is added by using
DALI_ECG_ADD (Page 67)), the parameters are saved in the CM 1xDALI (refer to data
flow path 1 (Page 23)) and sent to the physical device (refer to data flow path 5
(Page 23)).
● If the status of control gear is not configured, the parameters are only sent to the physical
device (refer to data flow path 5 (Page 23)).
● This function block does not check whether the input parameter EXT_PRM_SET is valid
for the specified control gear.
You can query the extended parameters of control gear by using
DALI_ECG_QUERY_EXT_PARAM (Page 75).