Siemens SIMATIC ET 200SP CM 1xDALI - Block diagram

Wiring
3.4 Block diagram
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
18 Manual, 06/2019, A5E46959434-AA
3.4
Block diagram
Requirements
For connecting, you require a BaseUnit:
● Type U0, Light color BaseUnit, article number 6ES7193-6BP00-0DU0
● Type U0, Dark color BaseUnit, article number 6ES7193-6BP00-0BU0
BaseUnit
The BaseUnit is not included in the scope of delivery of the module and must be ordered
separately.
You can find an overview of the BaseUnits that you can use with the technology module in
the product information for the documentation of the ET 200SP distributed I/O system
(https://support.industry.siemens.com/cs/ww/en/view/73021864).
You can find information about selecting a suitable BaseUnit in the ET 200SP Distributed I/O
System (https://support.industry.siemens.com/cs/ww/en/view/58649293) system manual and
ET 200SP BaseUnits (https://support.industry.siemens.com/cs/ww/en/view/59753521)
manual.
You can find information on wiring the BaseUnit, connecting cable shields, etc. in the
Connecting section of the ET 200SP Distributed I/O System
(https://support.industry.siemens.com/cs/ww/en/view/58649293) system manual.