Glossary
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
120 Manual, 06/2019, A5E46959434-AA
Type of address used to address a group of control devices in the system at once
The dimming curve defines how dimmers set voltage output in response to control signal
input, such as a slider position.
You can set the dimming curve of the control gear as below:
0: sets the dimming curve to linear.
1: sets the dimming curve to the standard logarithmic output characteristics.
Down switch off threshold
Value against which the virtual arc power level is continually compared, the output of the
control gear being switched off whenever the virtual arc power level reaches or passes this
level whilst decreasing.
Value against which the virtual arc power level is continually compared, the output of the
control gear being switched on whenever the virtual arc power level reaches or passes this
level whilst decreasing.
Test to check if the self-contained battery supplies the system within the limits of rated
duration of emergency operation.
The brightness of the lamp when the lamp is in emergency mode
The minimum brightness of the lamp when the lamp is in emergency mode
Mode in which mains supply has failed and whilst the control gear is powered by the battery
until deep discharge point
Time the device in emergency mode lasts
To Next Page
Loading...
