Parameters/address space
4.6 Explanation of parameters
ET 200SP F-TM Count 1x1Vpp sin/cos HF (6ES7136-6CB00-0CA0)
Equipment Manual, V1.0, 01/2021, A5E47073911-AA
37
RIOforFA safety
Specifies whether the module supports the "RIOforFA-Safety" profile. (Always set to "No" for
the F-TM Count module since RIOforFA is not supported.)
PROFIsafe mode
Specifies the PROFIsafe mode being used by the F-module.
PROFIsafe protocol version
Specifies the PROFIsafe protocol version being used by the F-module.
F-I/O DB manual number assignment
You must select the check box to manually set the DB number of the F-I/O DB. An F-I/O DB is
automatically created during compilation for each configured F-I/O module.
F-I/O DB number
The number of the F-I/O DB that is created during compilation.
F-I/O DB name
Specifies the symbolic name of the F-I/O DB that is created during compilation.
See also
S7-FCT V2.0 - Fail-safe Configuration Tool Operating Instructions
(https://support.industry.siemens.com/cs/ww/en/view/109763833)
SIMATIC Industrial Software SIMATIC Safety - Configuring and Programming
(https://support.industry.siemens.com/cs/ww/en/view/54110126)
To Next Page
Loading...
