Siemens SIMATIC ET 200SP - Page 90

Parameter data record
B.1 Parameter defaults and dependencies when configuring with GSD file
ET 200SP F-TM Count 1x1Vpp sin/cos HF (6ES7136-6CB00-0CA0)
88 Equipment Manual, V1.0, 01/2021, A5E47073911-AA
Safety monitoring
The following are safety monitoring default parameters:
SOS enable
SDI enable
SLS enable
Disabled
Disabled
Disabled
1
SOS tolerance
SDI tolerance
SLS speed
0
0
0
1
When SLS is enabled, a measured value other than velocity will result in a parameter error.