Programming the FM 351
6-20
FM 351 Positioning Module
C79000-G7076-C351-02
Typical Situations for the Transfer of Parameters:
• You edit the parameters with the configuration software. You then want the channels
of the module to have parameters assigned automatically during startup.
Action required: steps 1, 2 and 2a.
• You modify the parameters during commissioning in the test mode in the configuration
software: Action required: steps 4 and 5.
• You want the parameters modified during commissioning to be loaded automatically
during startup:
Action required: steps 1, 2 and 2a.
• You create the parameters with the configuration software. You want the channels of
the module to be assigned parameters during startup only by the user program using
data blocks:
Action required: steps 10, 10a and 6 or 10b and 6.
• You want to create data for recipes::
Action required: steps 10 and 10a.
• You create the parameters with the configuration software. These should be available
to the user program for temporary modifications.
Action required: steps 1, 2 and 2a for automatic parameter assignment.
Action required: steps 10, 10a, 9, 8 and 6 for access by the user program.
• You modify existing parameters (exclusively) with the user program:
Action required: steps 7, 9, 8 and 6.
• You want to view the data modified by the user program in the configuration software:
Action required: steps 11a and 11 or only 11b.
• The parameters modified by the user program should be downloaded automatically
during startup:
Action required: steps 11b or 11a, 11 and then 1, 2, 2a.
To Next Page
Loading...
