Siemens SIMATIC Ident - Page 63

Setting parameters for blocks
3.4 Programming Ident blocks
Ident profile and Ident blocks, standard function for Ident systems
Function Manual, 10/2018, C79000-G8976-C387-04
63
Table 3- 44 ATTRIBUTE "0xA2" (data type "IID_CM_STATUS_A2") compatible with RF18xC
Name
Type
Comment
Status info
BYTE
CM device status
hardware version
BYTE
Version of hardware
firmware_version
ARRAY[1..4] of
CHAR
Version of firmware
config ID
DWORD
Config ID as unix timestamp
serial_number
ARRAY[1..16]
of CHAR
Serial number
device type
BYTE
Type of device
upload request
BYTE
Upload request for fonfiguration data
active connections
BYTE
Active connections
io mode
BYTE
Mode of in-/outputs
low voltage
BYTE
Low voltage warning
reserved0
BYTE
Reserved
reserved1
BYTE
Reserved
number serial interfaces
BYTE
Number of serial interfaces by CM
serial_interface_data
ARRAY[1..4] of
IID_IN_SERIAL_
INTERFACE
serial_interface_data[1]
IID_IN_SERIAL_
INTERFACE
connection_status
BYTE
Status of communication between reader and CM
reader_type
CHAR
Type of connected reader
hardware_error
BYTE
Hardware error
reserved
BYTE
Reserved
serial_interface_data[2]
IID_IN_SERIAL_
INTERFACE
serial_interface_data[3]
IID_IN_SERIAL_
INTERFACE
serial_interface_data[4]
IID_IN_SERIAL_
INTERFACE
You will find more detailed information on the individual status modes in the manuals
matching the modes "FB 45", "FB55" and "SIMATIC RF620R/RF630R".
The identifiers of the status modes correspond to the following identifiers in the other
manuals:
0x81
≙
0x01
0x82
≙
0x02
0x83
≙
0x03
0x85
≙
0x05
0x87
≙
0x07
0x88
≙
0x08
0x90
≙
0x10
0x91
≙
0x11
0x92
≙
0x12
0xA0
≙
0x20
0xA1
≙
0x21