Setting parameters for blocks
3.4 Programming Ident blocks
Ident profile and Ident blocks, standard function for Ident systems
58 Function Manual, 10/2018, C79000-G8976-C387-04
The "Reader_Status" block reads status information from the reader or communications
module (RF18xC, "CM configuration_1") module. For the various reader families, there are
different status modes that you can select using the "ATTRIBUTE" parameter.
Figure 3-30 "Reader_Status" block
Table 3- 36 Explanation of the "Reader_Status" block
ATTRIBUTE Byte B#16#81 Identifier of the status modes / possi-
ble entries:
• RF200: 0x81
• RF300: 0x81, 0x86
• RF620R, RF630R: 0x87, 0x88,
0xA0, 0xA1
• RF61xR, RF68xR: 0x89
• RF185C, RF186C, RF188C: 0xA2
• MOBY U: 0x81, 0x84, 0x85
• MOBY D: 0x81
IDENT_DATA Any / Variant 0 Event values depending on attributes
Note:
You create either an "Array_of_Byte"
or a variable with one of the following
data types.
Other data types / UDTs can also be
To Next Page
Loading...
