Siemens SIMATIC Ident - Transponder Addressing

Setting parameters for blocks
3.6 Transponder addressing
Ident profile and Ident blocks, standard function for Ident systems
Function Manual, 10/2018, C79000-G8976-C387-04
113
3.6
Transponder addressing
Addressing
Addressing of the transponders is linear from address "0x0000" (or the specified start
address) to the end address. The CM or reader automatically recognizes the size of the
memory on the transponder. If the end address on the transponder is exceeded, you receive
an error message.
The next table shows the address space of the individual transponder parameters. The
"ADDR_TAG" and "LEN_DATA" parameters must be assigned according to this address
space.
Address space of the transponder/MDS variants according to ISO 15693 for RF200, RF300 and
MOBY D
System
Addressing
16-bit hexadecimal number
RF200,
RF300,
MOBY D
MDS D139 (I-Code 1; 44 bytes)
Start address
End address
0x0000
0x002B
ID-Nr.: (fixed-coded, can only be read as a whole)
Start address
Length
0xFFF0
0x0008
ISO-MDS (I-Code SLI; 112 bytes)
Start address
End address
0x0000
0x006F
ID-Nr.: (fixed-coded, can only be read as a whole)
Start address
Length
0xFFF0
0x0008
ISO MDS (Tag-it HF-I; 256 bytes)
Start address
End address
0x0000
0x00FF
ID-Nr.: (fixed-coded, can only be read as a whole)
Start address
Length
0xFFF0
0x0008
ISO MDS (my-d SRF55V10P; 992 bytes)
Start address
End address
0x0000
0x03DF
ID-Nr.: (fixed-coded, can only be read as a whole)
Start address
Length
0xFFF0
0x0008
ISO-MDS (MB 89R118B, 2000 bytes)
Start address
End address
0x0000
0x07CF
ID-Nr.: (fixed-coded, can only be read as a whole)