Setting parameters for blocks
3.5 Programming the Ident profile
Ident profile and Ident blocks, standard function for Ident systems
Function Manual, 10/2018, C79000-G8976-C387-04
71
With both variants, the variable table "PIB_CONSTANTS" is omitted. This no longer exists in
the library and must also be deleted from the user program.
Note
Check the content of the "PIB_CONSTANTS" variable table before deleting it
Before you delete
the "PIB_CONSTANTS" variable table, make sure that you have not
defined any of your own variables in this variable table. If you have created your own
variables, check whether these need to be moved to a different variable table.
Structure of the Ident profile
Note
Parallel operation using Ident blocks and Ident profile is not possible
Note that the CM or reader cannot be operated at the same time using the Ident blocks and
the Ident profile.
The blocks described in the section"Programming Ident blocks (Page 24)" represent a
simplified interface of the Ident profile. If the functionality available with the blocks is not
adequate for your application, you can use the Ident profile as an alternative. Using the Ident
profile, you can set complex command structures and work with command repetition. The
following graphic shows the Ident profile including the commands that can be implemented
with it.
Note
Ident profile for trained users
The Ident profile is a complex block containing all the functionality of the Ident blocks. The
Ident profile was developed specially for trained block users who want to configure complex
functions with their own
blocks. For untrained users, we recommend using the Ident blocks.
To Next Page
Loading...
Need help?
General