Siemens SIMATIC Ident - Page 114

Setting parameters for blocks
3.6 Transponder addressing
Ident profile and Ident blocks, standard function for Ident systems
114 Function Manual, 10/2018, C79000-G8976-C387-04
System
Addressing
16-bit hexadecimal number
Start address
Length
0xFFF0
0x0008
Address space of the transponder versions for RF300
System
Addressing
16-bit hexadecimal number
RF300
20 bytes of data memory (EEPROM)
R/W or OTP memory (EEPROM)
(The EEPROM user memory for RF300 can be used either as R/W memory or as an
OTP memory (see RF300 system manual))
Start address
End address
0xFF00
0xFF13
ID-Nr.: (fixed-coded; can only be output as a whole)
Start address
Length
0xFFF0
0x0008
8 KB data memory (FRAM/EEPROM)
R/W or OTP memory (EEPROM)
(The EEPROM user memory for RF300 can be used either as R/W memory or as an
OTP memory (see RF300 system manual))
Start address
End address
0xFF00
0xFF13
R/W memory (FRAM)
Start address
End address
0x0000
0x1FFC
Id-Nr.: (fixed-coded, can only be read out as a whole)
Start address
Length
0xFFF0
0x0008
32 KB data memory (FRAM/EEPROM)
R/W or OTP memory (EEPROM)
(The EEPROM user memory for RF300 can be used either as R/W memory or as an
OTP memory (see RF300 system manual))
Start address
End address
0xFF00
0xFF13
R/W memory (FRAM)
Start address
End address
0x0000
0x7FFC
ID-Nr.: (fixed-coded; can only be output as a whole)
Start address
Length
0xFFF0
0x0008
64 KB data memory (FRAM/EEPROM)
R/W or OTP memory (EEPROM)
(The EEPROM user memory for RF300 can be used either as R/W memory or as an
OTP memory (see RF300 system manual))