Siemens SIMATIC Ident - Page 59

Setting parameters for blocks
3.4 Programming Ident blocks
Ident profile and Ident blocks, standard function for Ident systems
Function Manual, 10/2018, C79000-G8976-C387-04
59
Results
Apply the correct data type that is assigned to the ATTRIBUTE value at the "IDENT_DATA"
input of the block so that the data can be correctly interpreted.
Note that the UDTs can only be used when the blocks "Reader_Status" or "Tag Status"
used.
Table 3- 37 ATTRIBUTE "0x81" (data type "IID_READSTAT_81_RF2_3_U")
Name
Type
Comment
status info
BYTE
SLG status mode
hardware
CHAR
Type of hardware
hardware version
WORD
Version of hardware
loader version
WORD
Version of loader
firmware
CHAR
Type of firmware
firmware version HB
BYTE
Version of firmware
firmware_version_LB
BYTE
driver
CHAR
Type of driver
driver version
WORD
Version of driver
interface
BYTE
Type of interface (RS 232/RS 422)
baud
BYTE
Baudrate
reserved1
BYTE
Reserved
reserved2
BYTE
Reserved
reserved3
BYTE
Reserved
distance limiting SLG
BYTE
Distance limiting of SLG
multitag SLG
BYTE
Multitag SLG
field ON control SLG
BYTE
Field ON control
field ON time SLG
BYTE
Field On time
sync SLG
BYTE
Synchronization with SLG
status ant
BYTE
Status of antenne
stand by
BYTE
Time of standby after command
MDS control
BYTE
Presence mode
Table 3- 38 ATTRIBUTE "0x84" (data type "IID_READSTAT_84_MOBY_U")
Name
Type
Comment
status info
BYTE
SLG status mode
number MDS
BYTE
Range 1..24
UID
ARRAY [1..24]
of DWord
Table 3- 39 ATTRIBUTE "0x86" (data type "IID_READSTAT_86_RF300")
Name
Type
Comment
status info
BYTE
SLG status mode
FZP
BYTE
Error counter passive: distortion without communication
ABZ
BYTE
Dropout counter
CFZ
BYTE
Code error counter
SFZ
BYTE
Signature error counter
CRCFZ
BYTE
CRC-error counter
BSTAT
BYTE
Status of last command
ASMFZ
BYTE
Error counter for host interface (ASM)
reserved0
ARRAY [1..17]