Siemens SIMATIC IPC BX-56A User Manual

Configuring firmware
3.4 "Advanced" tab
Firmware/BIOS description (SIMATIC IPC BX-56A, IPC BX-59A)
12 Operating Instructions, 10/2023, A5E52427534-AA
Key functions for setting the numeric time and date values
Key
Function
<Enter>
Switch between the setting options within a firmware setting, for example,
from hour to minute.
[+] [-]
Increase or decrease desired value.
[0] - [9]
Enter desired value.
3.4 "Advanced" tab
3.4.1 "Boot Configuration"
Basic display and input options during the boot procedure
Calling "Boot Configuration"
Select: "Setup Utility (Page 10)" > "Advanced" > "Boot Configuration".
Firmware
setting
Value Setting in
delivery state
Meaning
BX-56A
BX-59A
Numlock
Off
Numerical keypad is switched off after starting the device.
On
x
x
Numerical keypad is switched on after starting the device.
POST Errors
Never halt on
errors
Continue the booting process when errors occur.
Halt on all errors
Cancel the booting process when any errors occur
All without
keyboard
x
x
Cancel the booting process if errors occur, except for keyboard
errors.
3.4.2 "Memory Configuration"
Configure the memory.
This configuration is only available for SIMATIC IPC BX-59A.
Calling "Memory Configuration"
Select: "Setup Utility (Page 10)" > "Advanced" > "Memory Configuration".
Firmware setting Value Setting in
delivery state
Meaning
BX-59A
ECC Support
Enabled
x
DDR ECC (Error Correction Code) Support is enabled.
Disabled
DDR ECC Support is disabled.

Siemens SIMATIC IPC BX-56A Specifications

General

Brand	Siemens
Model	SIMATIC IPC BX-56A
Category	Industrial PC
Language	English