Siemens SIMATIC IPC BX-56A - USB Configuration

Configuring firmware
3.4 "Advanced" tab
Firmware/BIOS description (SIMATIC IPC BX-56A, IPC BX-59A)
18 Operating Instructions, 10/2023, A5E52427534-AA
Firmware setting
Value
Setting in delivery state
Meaning
Onboard Ethernet
2 Address
[Mac Address]
The Onboard Ethernet 2 address is defined by
this value.
Onboard Ethernet
3 (LAN 3, X3 P1)
Enabled
x
x
The onboard Ethernet interface "X3 P1" is
enabled.
Disabled
The onboard Ethernet interface "X3 P1" is
disabled.
Onboard Ethernet
3 Address
[Mac Address]
The Onboard Ethernet 3 address is defined by
this value.
Onboard Ethernet
4 (LAN 4, X4 P1)
Enable
x
x
The onboard Ethernet interface "X4 P1" is
enabled.
Disable
The onboard Ethernet interface "X4 P1" is
disabled.
Onboard Ethernet
4 Address
[Mac Address]
The Onboard Ethernet 4 address is defined by
this value.
3.4.10 "USB Configuration"
Calling "USB Configuration"
Select: "Setup Utility (Page 10)" > "Advanced" > "USB Configuration".
Firmware setting Value Setting in
delivery state
Meaning
BX-56A
BX-59A
USB Port Per-Port
Control
Enabled
Enable or disable the USB ports control.
Disabled
x
x
The following options show only when "USB Port Per-Port Control" = "Enabled".
NOTICE: USB X60, USB X61 and USB X62 are unavailable for IPC BX-56A.
USB X60
Enabled
x
Enable or disable the USB X60.
Disabled
USB X61
Enabled
x
USB X61 is enabled permanently.
USB X62
Enabled
x
Enable or disable the USB X62.
Disabled
USB X63
Enabled
x
x
Enable or disable the USB X63.
For IPC BX-56A, USB X63 is enabled permanently.
Disabled
USB X64
Enabled
x
x
Enable or disable the USB X64.
Disabled
USB X65
Enabled
x
x
Enable or disable the USB X65.
Disabled
USB X66
Enabled
x
x
Enable or disable the USB X66.
Disabled
USB Port
(Internal USB
X9300)
Enabled
x
x
Enable or disable the Internal USB X9300.
Disabled