Siemens SIMATIC IPC427C - Installing drivers and software

Maintenance and Service
11.4 Installing drivers and software
SIMATIC IPC427C
Operating Instructions, 04/2009, A5E02414743-01
83
11.4 Installing drivers and software
11.4.1 Driver installation under Windows Embedded Standard 2009
The driver installation under Windows Embedded Standard 2009 is conducted in the same
way as under Windows XP Professional. Pay attention to the installation instructions of the
driver manufacturer.
When installing drivers under Windows Embedded Standard 2009, you may see a prompt for
the "Windows XP Installation CD".
● In this case, insert the Restore DVD.
The required files are in the folder \Drivers_WES.
● Disable the Enhanced Write Filter before installing drivers and enable it again when you
are finished.
11.4.2 Installing drivers and software
NOTICE
Before you install new drivers or updates for multilingual operating systems, (MUI versions),
reset the regional settings for menus and dialogs and the default language to US English.
Install the drivers and software from the included "Documentation and Drivers" CD.
Procedure:
1. Place the CD into the drive.
2. Start the program with "START".
3. Select "Drivers & Updates" from the index.
4. Select the operating system in "Drivers & Updates".
5. Install the required driver.
NOTICE
For new Windows XP Professional installations, the chipset driver must be installed
before you install any other drivers.