Installing/mounting
5.4 Mounting on DIN rails
SIMATIC IPC427C
28 Operating Instructions, 04/2009, A5E02414743-01
5.4 Mounting on DIN rails
Mounting the device on DIN rails
Note
Use of Siemens 35 mm standard mounting rail is recommended.
Steps for mounting on DIN rails
1. Set the device inclined on the
upper DIN rail.
2. Swing the device fully onto the rails
until both clamps completely latch.
Note
To ensure secure mounting on vertical mounting rails, a DIN rail ground terminal should be
mounted beneath the device.
To Next Page
Loading...
