Expanding the device and assigning device parameters
6.5 Installing and removing a DVD drive (built-in unit only)
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 11/2016, A5E31347228-AF
143
Note
Note the protective measures required when working with ESD in the section "
ESD guideline
185)".
Remove the marked screws and take off
the rear panel of the of the enclosure.
Remove the marked screw and pull out
the connector in the direction of the a
r-
Remove the marked screws.
e the third screw on the oppo-
site side. Lift the DVD drive off the base
plate.
Follow the steps for installation in reverse order.
To Next Page
Loading...
