Commissioning the device
4.4 Notes on various device configurations
SIMATIC IPC477D, IPC477D PRO
110 Operating Instructions, 11/2016, A5E31347228-AF
Installing IPC Wizard
Requirement
● The system requirements are met.
● Do not apply with factory state: If following previous driver versions exist, uninstall them
via "Start > Control Panel > Programs and Features":
– IPC Wizard V1.0
– IPC Wizard V2.0
– IPC Switch Touch Mode V1.0.0.0
1. Turn on the PC.
– With the factory state of some IPCs, the SIMATIC IPC Wizard is pre-installed. The
installation starts the first time the PC is switched on.
– If your SIMATIC IPC was delivered without pre-installed software, start the installation
of the SIMATIC IPC Wizard from the "Documentation and Drivers" CD/DVD. Select
the appropriate IPC Wizard for your device.
To Next Page
Loading...
