Siemens SIMATIC IPC477D - Replacing the SSD (PRO Device)

Maintaining and servicing your device
7.4 Installing and removing hardware
SIMATIC IPC477D, IPC477D PRO
162 Operating Instructions, 11/2016, A5E31347228-AF
7.4.2.2
Replacing the SSD (PRO device)
Requirements
● The device is disconnected from the power supply.
● The device is open, see the section "Opening and closing the backplane cover PRO
device (Page 135)".
● An SSD. The SSD is installed in the backplane cover.
● T10 screwdriver
Procedure
1.
Pull out the connector
s ①, ② and ③.
Take into account the safety latch of the
cable in doing so.
2.
Set the backplane cover down flat.
3.
Remove the indicated pan
-head screws
and fi
rmly hold down the cover ④ of the
power supply.
4.
Remove the drive cage with the SSD and
power supply and place it with the back
facing up.