Siemens SIMATIC IPC477D - Page 145

Expanding the device and assigning device parameters
6.6 Installing and removing a CFast card
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 11/2016, A5E31347228-AF
145
Procedure
The procedure for installing and removing the CFast card in an external slot is the same for
all device variants.
Installation
Note
Carefully insert the CFast card into the slot without applying excess force.
1.
For built
-in unit only: Release the lock of
the cover.
In so doing, press against the cover in
the direction of the arrow. Open the cover
completely.
2.
For PRO device only: Remo
ve the indi-
cated screws of the cover.
3.
Insert the CFast card into the external
slot as shown in the figure.
Push the CFast card into the slot until it
clicks i
nto place (ballpoint pen mechan-
ics).
4.
Close and lock the cover.
Removal
Perform the steps in reverse order.