Siemens SIMATIC PCS 7 - Page 38

Replacing hardware
4.1 Use of new hardware
Compendium Part D - Operation and Maintenance (V9.0)
38 Operating Manual, 02/2018, A5E43228948-AA
Monitoring on the system side
The definition specifies that individual HSPs cannot be used with PCS 7 but can only be
used for HUPs approved for PCS 7.
If an HSP is used without accompanying meta information, the module drivers cannot be
generated. as indicated by the message "Module is not supported by the module driver"
(shown in the figure, using an ET 200M module as an example). As a result, no diagnostics
or status messages of the hardware can be processed.