Maintenance and service
11.2 Reinstalling the software
SIMATIC Rack PC 547B
78 Operating Instructions, 12/2007, A5E01127519-02
Note
Once you have change the configuration of your hard disk with DiskPart, you will need to
reboot the PC for the changes to go into effect.
Boot once again from the Recovery CD to format the partitions.
Format primary partition
1. Boot from the Recovery CD to format the partitions. Follow the screen instructions until
the Recovery functions window is displayed.
2. Select "Start command prompt" in the Recovery functions window. Enter the following
command in the displayed command prompt:
format drive:/FS:file system
drive = drive letter of the partition to be formatted. Valid values: C, D, E, F etc.
File system = Specifies the type of file system. Valid values: FAT, FAT32, NTFS.
NTFS is the factory setting for all Windows operating systems.
Example for the primary hard disk in the system:
format C:/FS:NTFS
format /? Shows all parameters of the command.
To Next Page
Loading...
