Transponder
7.10 SIMATIC RF625T
SIMATIC RF600
392 System Manual, 11/2018, J31069-D0171-U001-A21-7618
7.9.5 Certificates and approvals
Conformity with the RED directive 2014/53/EU
Conformity with the RoHS directive 2011/65/EU
Federal Communications
Passive labels and transponders comply with the valid regulations;
certification is not required.
7.10 SIMATIC RF625T
7.10.1 Characteristics
The SIMATIC RF625T transponder is a passive, maintenance-free data carrier with a round
design. It operates based on UHF Class 1 Gen 2 technology and is used to save the
"Electronic Product Code" (EPC) of 96 bits/128 bits. The transponder also has a 512-bit user
memory.
The areas of application are industrial asset management, RF identification of tools,
containers and metallic equipment.
The Disk Tag is small and rugged and suitable for industrial applications with degree of
protection IP68. It is highly resistant to oil, grease and cleaning agents.
Ideally, the SIMATIC RF625T is mounted directly on a flat metal surface of at least 150 mm
diameter where it achieves a typical sensing distance of 1.5 m.
Identification tasks in rugged industrial environments
Frequency range
• ETSI: 865 to 868 MHz
• FCC: 902 to 928 MHz
According to ISO 18000-63
Memory
• EPC: 96 / 128 bits
• User memory: 64 bytes
1)
Mounting Designed for direct mounting on conductive materials
1)
Depending on the environment, the reader/the antennas and the set power
To Next Page
Loading...
Need help?
General
