EasyManuals Logo

Siemens SIMATIC RF600 Series User Manual

Siemens SIMATIC RF600 Series
490 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #466 background imageLoading...
Page #466 background image
Accessories
10.1 Wide-range power supply unit for SIMATIC RF systems
SIMATIC RF600
466 System Manual, 11/2018, J31069-D0171-U001-A21-7618
NOTICE
Restriction to the approval of the wide-range power supply
Alterations to the SIMATIC RFID modules and devices as well as the use of SIMATIC RFID
components with third-party RFID devices are not permitted.
Failure to observe this requirement shall constitute a revocation of the radio equipment
approvals, CE approval and manufacturer's warranty. Furthermore, the compliance to any
salient safety specifications of VDE/DIN, IEC, EN, UL and CSA will not be guaranteed.
Safety notes for the US and Canada
The readers of the SIMATIC RF600 series may only be operated with the wide range power
supply unit for SIMATIC RF systems - as an optional component or with power supply units
that are UL-listed in combination with the safety standards specified below:
UL 60950-1 - Information Technology Equipment Safety - Part 1: General Requirements
CSA C22.2 No. 60950 -1 - Safety of Information Technology Equipment
NOTICE
Warranty
The compliance of the SIMATIC RFID systems to the safety standards mentioned above
and the conditions in the UL approval will not be guaranteed if neither the wide-range
power supply unit for SIMATIC RF systems nor power supplies listed according to the
safety standards named are used.
10.1.5 Mounting & connecting
The wide-range power supply unit for SIMATIC RF systems is sold with a country-specific
power cable for EU, UK and US.
Note
Country-specific adaptation of the connector
When necessary, the primary cable can be adapted to country
-specific conditions. The
connector can be replaced by a country
-specific connector.
If you do this, make sure that the protective conductor
is connected in the connector and that
grounding is ens
ured. If the protective conductor cannot be connected through the plug, you
must connect the grounding connection to the mounting hole
provided by the metal shoe.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC RF600 Series and is the answer not in the manual?

Siemens SIMATIC RF600 Series Specifications

General IconGeneral
BrandSiemens
ModelSIMATIC RF600 Series
CategoryRfid Systems
LanguageEnglish

Related product manuals