RF600 system planning
4.6 Planning and installation of UHF read points
SIMATIC RF600
System Manual, 11/2018, J31069-D0171-U001-A21-7618
63
Adjust antennas
Follow the steps below to optimize the antenna alignment:
1. Position the object fitted with a transponder and to be identified at the required read point.
2. Align the reader or the antenna so that its front points in the direction of the object
(transponder) to be identified.
Keep to the minimum distances between antennas and transponders to avoid antenna
errors.
When using linear antennas, make sure the polarization direction is correct.
3. In the "Settings - Adjust antenna" menu item, select the connected antenna and click the
"Start adjustment" button.
Figure 4-14 Optimizing the antenna alignment with the "Settings - Adjust antenna" menu item of the
WBM
To Next Page
Loading...
