Device maintenance and repair
7.5 Installing the software
SIMATIC IPC547G
Operating Instructions, 04/2020, A5E49948632-AA
133
Load Driver Integration of controller drivers unknown to the operating system and required for
installation. Please read the information in the section "Information for systems
with RAID or AHCI controller".
Changing the partition size
Identification for error messages, for example, if the data medium was not for-
matted in the required "NTFS" format.
Note
If you want to install the operating system on a data medium connected to a storage
controller unknown to the operating
system, you have to integrate the driver of the storage
controller. Integrate this driver before you partition the data medium and before you install
the operating system. For more information on integrating the storage controller, refer to the
section "In
formation for systems with RAID or AHCI controller".
1. Make sure that the partition on which you want to install the operating system is large
enough and is set up with a NTFS file system.
The recommended minimum size of this partition varies depending on which operating
system, how much work memory and which additional software you want to use. You can