Siemens Simatic series User Manual

Expanding and assigning parameters to the device
6.6 Drives
SIMATIC IPC547G
Operating Instructions, 04/2020, A5E49948632-AA
89
6.6.6 Hard disk or SSD, device with drive cage type A
Requirement
● The device is equipped with the drive cage type A.
● The device is fully disconnected from the mains voltage, see section "Switching off the
device (Page 63)".
● The device is open; see section "Open the device (Page 76)".
● Screwdriver T10 for loosening the HDD
● Screwdriver T8 for loosening the SSD
See also
Opening the front door (Page 76)
6.6.6.1 Installing a hard disk drive or SSD in slot 0 to 2
Procedure
1. Press the locks ① of the cover ③ together inside the device and keep them pressed.
2. Push the locks to the front in the direction of the arrow
②.
3. Remove the cover
③ upwards at an angle at the front of the device.
4. Remove the now freely accessible slot cover
④. If required, remove other slot covers or
removable trays until the drive cage is freely accessible.

Siemens Simatic series Specifications

General

Processor	Intel Core i3, Core i5, Core i7
Operating System	Windows 10 IoT Enterprise, Linux
Storage	SSD, HDD
Interfaces	Ethernet, USB, RS-232/485
Ports	Ethernet, USB, Serial
Mounting	DIN rail, wall
Protection Class	IP65
Graphics	Integrated Intel HD Graphics
Expansion Slots	PCIe
Power Supply	24V DC or 100-240V AC
Operating Temperature	0°C to 50°C (depending on model)