Description
30 REVISION 02 * DESCRIPTION SIMOSEC * 832-6063.0
9.4 Standards and guidelines
SIMOSEC switchgear complies with the following relevant standards and specifications:
IEC-, ANSI-, IEEE-Standards • IEC 62271 - 105
• ANSI/IEEE Std C37.20.3 - 2001
• ANSI/IEEE Std C37.20.4 - 2001
• ANSI/IEEE Std C37.57 - 2003
• ANSI/IEEE Std C37.58 - 2003
• ANSI/IEEE Std 1247 - 2005
• ANSI/IEEE Std C37.22 - 1997
• CSA C22.2 No. 193 - M 1983
• CSA C22.2 No. 31-04
• EEMAC G11-1 (Measurement of Corona)
Transport regulations
According to Annex A of the European agreement about international transport of
hazardous materials (Anlage A des Europäischen Übereinkommens über die
internationale Beförderung gefährlicher Güter auf der Straße (ADR), SF
6
gas insulated
medium voltage switchgear manufactured by Siemens is not categorized as hazardous
materials with respect to transport procedures, and are exempt from special transport
regulations according to ADR, Section 1.1.3.1 b.
9.5 Type of service location
SIMOSEC switchgear can be used in an indoor installation in accordance with
IEC 61 936 (Power installations exceeding AC 1kV) and VDE 0101 and the NEC:
• Outside lockable electrical service locations at places which are not accessible to the
public. The equipment enclosure in which the indoor SIMOSEC switchgear is installed
must have doors that are lockable.
• Inside lockable electrical service locations. A lockable electrical service location is a
room or place which is reserved exclusively for the operation of electrical equipment
and is kept under lock and key. Access is restricted to authorised personnel and per-
sons who have been properly instructed in electrical engineering. Untrained or unskil-
led persons may only enter under the supervision of authorised personnel or properly
instructed persons.
• In any event, access to the equipment must be restricted to authorized personnel.
To Next Page
Loading...
