832-6063.0 * INSTALLATION SIMOSEC * REVISION 02 37
Installation
Inspection Ö Make further inspection, if practical, for possible concealed damage while the
carrier's inspector is on site.
Ö Do the inspection for concealed damage within 15 days of receipt of equipment if it
is not practical at the time the carrier's inspector is present.
Ö Notify the carrier again and make inspection if concealed damage is found, prior to
taking any corrective action to repair.
Ö Notify Siemens sales office immediately.
Documentation & Repair The carrier inspection report and/or driver's signature on the delivery receipt does not
constitute approval to repair.
Ö Obtain the original of the carrier inspection report and forward it along with a copy of
the noted delivery receipt to the Siemens sales office.
Ö Siemens must have approval from the carrier before any repair work can be
performed.
Ö The documents must be provided to Siemens before approval can be obtained,
Note: Any determination as to whether the equipment was properly loaded or properly
prepared by shipper for over-the-road travel cannot be made at the destination.
Shipments are not released from the factory without a clear bill of lading. Approved
methods are employed for preparation, loading, blocking and tarping of the equipment
before it leaves the Siemens factory. Therefore, if the equipment is received in a
damaged condition, this damage to the equipment had to occur while enroute due to
conditions beyond Siemens control. lf the procedure outlined above is not followed by
the consignee, purchaser, or his agent, Siemens cannot be held liable for repairs.
Siemens will not be held liable for repairs in any case where the work was performed
prior to authorization from Siemens.
To Next Page
Loading...
Need help?
General
