Manually backing up
Requirements
● The inverter power supply has been switched on.
● No memory card is inserted in the inverter.
Procedure with STARTER
Proceed as follows to back up your settings on a memory card:
1. Go online.
2. Press the “Copy RAM to ROM” button .
3. In your drive, select "Drive Navigator".
4. Select the "Commissioning" button.
5. Select the button to transfer the settings to the memory card.
6. Select the settings as shown in the diagram and start the data backup.
7. Wait until STARTER signals that the data backup has been completed.
8. Close the screen forms.
Saving settings and series commissioning
7.1 Saving settings on a memory card
SINAMICS G120C converter
324 Operating Instructions, 09/2017, FW V4.7 SP9, A5E34263257B AF
To Next Page
Loading...
