Changes in the current manual
Notable changes since the 11/2016 edition of the Manual
New hardware
● Operator Panel IOP replaced by Intelligent Operator Panel 2 (IOP-2).
Installing the inverter (Page 50)
Tools to commission the inverter (Page 116)
● dU/dt filter plus Voltage Peak Limiter
Mount dU/dt filter plus Voltage Peak Limiter (Page 62)
Hardware, which is no longer described in the current operating instructions
Frame size FSA, power range 0.55 kW … 2.2 kW
Information on inverters FSA, 0.55 kW … 2.2 kW is provided in Edition 11/2016 of the operating
instructions.
Operating instructions SINAMICS G120C, FW V4.7 SP6 (https://
support.industry.siemens.com/cs/ww/en/view/109744769)
New functions
● Telegram 350 added for PROFIBUS and PROFINET
Drive control via PROFIBUS or PROFINET (Page 179)
● Improved method for optimizing the efficiency of standard induction motors
Efficiency optimization (Page 311)
● End position control with two limit switches
Limit position control (Page 202)
● The inverter issues an alarm if a memory card is not inserted.
Activate message for a memory card that is not inserted (Page 332)
Overview of all new and modified functions in firmware V4.7 SP9:
Firmware version 4.7 SP9 (Page 429)
SINAMICS G120C converter
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34263257B AF 5
To Next Page
Loading...
