Siemens SINAMICS G150 - 7 Setpoint Channel and Closed-Loop Control; Chapter Content

SINAMICS G150
Operating Manual
7-1
7Setpoint Channel and Closed-Loop
Control
7
7.1 Chapter Content
This chapter provides information on the setpoint channel and closed-loop control
functions.
• Setpoint channel
– Direction reversal
– Suppression speed
– Minimum speed
– Speed limitation
– Ramp generator
• Closed-loop control (in preparation)
Cabinet operator panel
PROFIBUS
Input terminals
-A60
M
~
Output terminals
-A60
Diagnosis Faults / alarms Monitoring Functions Protective functions
Setpoint channel Closed-loop control
576
8
910