SINAMICS G150
Operating Manual
5-1
5Commissioning
5
5.1 Chapter Content
This chapter provides information on the following:
• An overview of the operator panel functions
• Initial commissioning of the cabinet (initialization)
– Entering the motor data (drive commissioning)
– Entering the most important parameters (basic commissioning), concluding
with the motor ID
• Data backup
• Resetting parameters to the factory settings
Cabinet operator panel
PROFIBUS
Input terminals
-A60
M
~
Output terminals
-A60
Diagnosis Faults / alarms Monitoring Functions Protective functions
Setpoint channel Closed-loop control
576
8
910
To Next Page
Loading...
