EasyManua.ls Logo

Siemens SINAMICS G150 - Page 194

Siemens SINAMICS G150
240 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Diagnosis / Faults and Alarms 11/03
SINAMICS G150
10-52 Operating Manual
F35883 CU DRIVE-CLiQ: Hardware defect
Reaction: OFF2
Cause: DRIVE-CLiQ communication between control unit and at least one other component is
defective.
Fault value
(r0949):
Bit 0 - 7: Number of the affected component
Bit 8 - 31: Reserved
Remedy: - Replace Control Unit.
Acknowl.: Immediate
F35884 CU DRIVE-CLiQ: Redundancy link error
Reaction: OFF2
Cause: Reserved for later use.
Remedy: Reserved for later use.
Acknowl.: Immediate
F35885 CU DRIVE-CLiQ: fault in cyclic data transfer
Reaction: OFF2
Cause: DRIVE-CLiQ communication between control unit and at least one other component is
defective.
Fault value
(r0949):
Bit 0 - 7: Number of the affected component
Bit 8 - 31: Reserved
Remedy: - Check firmware states of affected components.
- Replace affected component.
Acknowl.: Immediate
F35886 CU DRIVE-CLiQ: Data transfer faulted
Reaction: OFF2
Cause: DRIVE-CLiQ communication between control unit and at least one other component is
defective.
Fault value
(r0949):
Bit 0 - 7: Number of the affected component
Bit 8 - 31: Reserved
Remedy: - Check firmware states of affected components.
- Replace affected component.
Acknowl.: Immediate
F35887
F35888
CU DRIVE-CLiQ: Hardware defect
Reaction: OFF2
Cause: DRIVE-CLiQ communication between control unit and at least one other component is
defective.
Fault value
(r0949):
Bit 0 - 7: Number of the affected component
Bit 8 - 31: Reserved
Remedy: Replace Control Unit.
Acknowl.: Immediate
F35889 CU DRIVE-CLiQ: Data transfer faulted
Reaction: OFF2
Cause: DRIVE-CLiQ communication between control unit and at least one other component is
defective.
Fault value
(r0949):
Bit 0 - 7: Number of the affected component
Bit 8 - 31: Reserved
Remedy: - Check for break in DRIVE-CLiQ or faulty contacts in connector.
- Check 24 V supply of affected component.
- Replace affected component.
Acknowl.: Immediate
A35890 CU DRIVE-CLiQ: Connection setup
Cause: DRIVE-CLiQ communication between control unit and at least one other component is
defective.

Table of Contents

Other manuals for Siemens SINAMICS G150

Related product manuals