Installing
3.4 Mounting the Power Modules
Power Module PM240-2
40 Hardware Installation Manual, 01/2020, A5E33294624B AL
Mounting the shield plate, FSG
Procedure
Proceed as follows to mount the shield plate:
● If you are using a Brake Relay to control a motor holding brake, then mount the Brake
Relay at the rear of the shield plate.
Mounting and connecting the brake relay (Page 143)
● Secure each side part to the shield plate with two screws
①.
● Fasten the EMC connecting bracket to the shield plate with four screws
②.
● Screw the shield plate to the converter together with the side parts and EMC connecting
bracket using four screws
②
You have mounted the shield plate.
To Next Page
Loading...
